fbpx

 

                               

The result of poor lubrication

Studies have shown that inappropriate lubrication represents 53% of all bearing failures!

 

Inappropriate lubrication is a major cause for downtime and unnecessary maintenance costs which consists of replacing parts. The labor to repair and replace the bearings, the unforeseen downtime and the impact of respecting delivery to clients. The primary cause of these breakdowns are caused by contamination, dust, dirt and humidity or insufficient greasing applied to the bearings.

 

 

Inefficient manual lubrication can lead to over lubricating that can lead to indirect costs, which is very true. Wasting lubricant, environmental problems, security problems or maintenance and higher labor costs.

 

Successful businesses are constantly seeking new solutions and technologies to reduce costs, minimizing down time and maximizing productivity. Could automatic lubrication be a solution?

 

The automatic lubrication system helps to eliminate unforeseen and unnecessary expenses. An automatic lubrication system lubricates many points on a machine from a pump/centralized unit placed in an accessible place. Specifically for mobile and fixed construction equipment, a system distributes small quantities of grease at frequent intervals, while your equipment is running, by maintaining a consistent amount of grease being distributed to the bearings at all times and seals which prevents dirt and contaminants to infiltrate in the bearings. This is a contrast with the conditions of lack of grease often associated with manual lubrication done by the operator if and when he has time or feels like it.

 

 

 

The numerous advantages of using an automatic lubrication system:

 

Security

The security of personnel in the work area today is essential. An ALS reduces and eliminates the operator from climbing on the machine and crawling under the machine or in difficult to reach areas.

 

Efficient Lubrication

An automatic lubrication system applies grease while the machine is operating, which signifies less downtime and when the bearings are in action all internal surfaces of the bearings are continuously exposed and benefits for a better application of grease.

 

Better Lubrication

Grease application is more efficient when distributed in measured quantities on short and frequent intervals. Unfortunately with strict delivery schedules, the constraints of labor and relocating the equipment makes it impossible to grease manually. The equipment is greased when available and if there is someone who has time to do it.

 

 

Better maintenance

Numerous traditionalists over grease by pumping the grease up to the bearing until it overflows. As previously indicated, frequent and small measured quantities will give the bearings a better protection. In addition to over/under greasing, you will have less overflow. The end results is less waste and contamination on your equipment, or construction site. The security (dangers of slipping) and the environmental problems play an important role related to over greasing.

 

Less down time, reduced maintenance costs and reduced parts replaced

The time and labor constraints makes it impossible to respect the required greasing of the machine. Preventative maintenance supplied by an ALS is undeniable good for respecting the required lubrication, reducing maintenance costs and minimizing downtime by prolonging the lifespan of numerous axles, rings and components on the equipment. You will also be stocking less replacement parts related to greasing.

 

 

General increase in productivity

Resulting in an increased availability of the machine and a reduction of downtime due to a breakdown or general maintenance.

 

Longer lifespan and greater re-sale value

Given that the bearing surfaces are always protected and that your machine in general will be better maintained.

 

Helping the environment

Less premature wear of the bearings and other significant components, less parts to replace. Most of all seeing as you are not over lubricating by greasing manually, there is less environmental contamination.

 

 

For more information about Allfett automatic lubrication 

 

 

Don't wait until problems occur!

Contact your sales representative to know which products if offered for your industry.