Midwest Hose has installed its first automatic lubrication system


First installation for Midwest Hose


Midwest Hose, an authorized distributor for the United States, installed its first automatic lubrication system last February. The installation was done on a Komatsu PC490LC excavator with the help of the Alltech Group team.

Midwest has meet the industry standard.



Follow-up after 100 hours of use


Installing the lubrication system is one thing, but you still have to make sure that it has been done well and that the calibration meet the manufacturer's standards. It is necessary to check that each point receives the right amount of grease, in a precise time interval.

Midwest team went to the customer to analyze the lubrication system after 100 hours of use. Analysis has shown that the system works wonderfully .

Each point receives an ideal level of lubricant; a small amount is sent at a time. It also protects the surface against contamination. It creates a barrier to sand, water and other contaminants which may have an abrasive effect on the surface. Regular lubrication prevents premature wear!





To understand all the advantages related automatic lubrication, consult the article « Manual lubrication versus automatic lubrication - Are you still not convinced? »  


Learn more about Midwest Hose team:



Don't wait until problems occur!

Contact your sales representative to know which products if offered for your industry.



Contact us

Alltech Group
250, rue Rodolphe-Besner #30,
Vaudreuil-Dorion, Qc, J7V 8P2

Phone: 450.218.6677
Toll free: 1.855.730.5555
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.

Opening hours:
monday to friday 8h am to 4h30 pm

© 2015 Groupe Alltech. All Rights Reserved.